Pressure control assembly
To visualize the hydraulic pressure that there is during the work phase of the cylinder , there is a pressure control assembly
Pressure control assembly ( Sensor)
To visualize the hydraulic pressure that there is during the work phase of the cylinder , there is a pressure control unit .
For more precision, there are sets of sensor pressures Consisting of a pressure sensor and a 12-G1/4 test adapter. Once the assembly is screwed onto the cylinder’s pressure tap, the pressure control assembly will deliver the pressure that resides in the cylinder. It exists with an adapter or a capillary if necessary.
Voir le produit
TOOL HOLDING PO2C
Tool holding made up of 2 parts, the male part which is screwed onto the cylinder rod and the female part made up of 2 half-shells.
It attaches to the tooling or to a mobile plate.
This tool holder is available in all sizes from UP 20 to UP 500.
TOOL HOLDING POCB
Made up of 2 left (FIXTURE / COUPLING FLANGE) this chuck allows to assure the connection between the power unit and the equipment.
Voir le produit
TOOL HOLDING POAR
It carries tool consists of 2 parties, carries it tool and its stalk of anti-rotation.
It exists in all the sizes of cylinder amplifier of effort (from 20 to 500).
Manual Oil Pump ( 70.60.00).
This filling pump is used to fill pneumatic-hydraulic power units with oil.
Can of Oil 5L
Can of 5 liters of red oil (OLIR UP) to reload the power unit ENERFLUID
